How to Refinish Your Hardwood Floor

Hardwood flooring, like all wood products, requires attention to maintain, said a flooring company in Orlando. You will find a vast number of books and videos on the Internet that can show you the right ways to care for your hardwood floor. You can even find some home improvement stores where you can find these books and videos. Some may even offer to install your floors for you for a nominal fee.

The first step you need to take in refinishing your wood floor is to remove all the existing wood from the affected areas. You should start by removing the surface stains, such as fingerprints or marks left by sandpaper, and any type of paint. You will also have to remove any wax stains.

Next you must be careful to remove any type of finishes that have been applied to the wood itself. While it is possible to apply paint to the floor, you may want to try out some different options before you decide to use this method. You may want to think about using a primer instead if you would like to achieve a uniform finish.

Refinishing is not something that you do often but it does happen quite often. When you think of hardwood floors you probably think of years of wear, but this is really no reason to give up. There are many different methods that you can use to help you restore your hardwood floor and this article is going to give you some ideas on how to do just that.

Before you begin the refinishing process you should first vacuum all the dust off the wood and any other debris that has fallen onto it. This will make the floor look new. The next step is to sand the floor until it is as smooth as possible. If you are refinishing faded hardwood flooring then you may have to sand it again. Once this is done you can go over it with a special wood preservative. Once you have finished sanding you should coat it with a sealant to protect it.

After you have covered the floor with the new finish, you will want to apply a new layer of sealant to make sure that the floor stays that way. You can also apply a protective coating to make sure that any scratches don’t get any deeper. You will probably have to sand the floor a few times after this and reapply the sealant. If you need a hardwood floor refinishing contractor just click here.